![]() Version 16 *When complete, return back to version I started with. Every command underneath the occurrence of “version #” will be run in compliance with Stata#, where # was specified in “version” command The “version” command is treated as an umbrella term. Where # is the version of Stata you want following commands to be run under. To run a bunch of commands with earlier Stata syntax, use “version #”.Note: An asterisk “*” in Stata and in this FAQ denote a comment, Stata does not interpret these. Version *output will be version 16, Stata16 is most recent version on CCSS-RS servers. First, only typing “version” into command prompt will output current Stata version in use.The version command was added for Stata14. You can use “version” to run Stata commands of a specific version. Stata is backwards compatible however, command syntax for a previous version of Stata may not be identical to that of a newer version. This will be talked about more later on in this FAQ. Note: I included the “version(#)” option at the end of the “saveold” command. To save to an older version you must open data in Stata11 and use saveold again to go to an earlier version. Important: Stata15 can only save back to version 11. ![]() Using the “saveold” command.Įxample: My data is of version 15, but I want to save the data so I can use it in Stata11.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |